WTS Direct Powered Transponder Specification
Dimensions: 19x19x6mm
Weight: 4g
Humidity: max 90% relative
Signal transfer: magnetic induction
Transponder position: horizontal
Max height 15cm Power feed: RX channel or battery
Connection plug: standard servo plug
Operating voltage: 3V-16VDC (reverse polarity protected)
Power consumption: 14mA @ 6V
Display LED: ultra-bright RED
WTS Instruction
The WTS transponder is compatible with all RC systems including RC version 4 decoders with firmware 4.4 or lower.
Operation is purely lap counting and timing using its 7 DIGIT ID number.
The transponder is ready to be used right away simply by connecting to a battery or plugging into a free receiver channel or the BATT socket.
After power on LED will flash fast. WTS power cable is flexible can be easily replaced. Preheat black part of transponder to 80¡ÆC and slowly remove PCB from case.
Solder new cable to PCB pads, check polarity. Insert PCB again to the case. Use "hot glue" to close the case.